Front Seat Back Frame Replacement

WARNING: This page is about a different car, the 2022 Cadillac CT5. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedure Front Seat Back Cover and Pad Replacement
1	Driver or Passenger Seat Back Frame Bolt [4x] CAUTION: Refer to Fastener Caution . NOTE: Refer to the procedure link for torque specification. Procedure Remove the seat back frame bolts. If NEW threaded components are being installed, loosen the adhesive using a metal pick or similar tool before proceeding. If threaded components are reused, prepare the threaded components using the following steps: Remove any loose cured adhesive from the external threads of the component using a lint free cloth. Thread the cleaned component into the internal mating threads and remove to loosen trapped cured adhesive. Apply thread locking adhesive to the external threads of the component. Adhesives, Fluids, Lubricants, and Sealers Ensure there are no gaps in the thread locking adhesive once applied to the component. Tighten 45 N.m (33 lb ft)
2	Driver or Passenger Seat Back Cushion Frame Procedure Disconnect and reposition harness as necessary. Transfer components as necessary.

Callout

Component Name

Preliminary Procedure
Front Seat Back Cover and Pad Replacement

Driver or Passenger Seat Back Frame Bolt [4x]

CAUTION:

Refer to Fastener Caution .

NOTE:

Refer to the procedure link for torque specification.

Procedure

Remove the seat back frame bolts.
If NEW threaded components are being installed, loosen the adhesive using a metal pick or similar tool before proceeding. If threaded components are reused, prepare the threaded components using the following steps:
1. Remove any loose cured adhesive from the external threads of the component using a lint free cloth.
2. Thread the cleaned component into the internal mating threads and remove to loosen trapped cured adhesive.
3. Apply thread locking adhesive to the external threads of the component. Adhesives, Fluids, Lubricants, and Sealers
4. Ensure there are no gaps in the thread locking adhesive once applied to the component.

Tighten
45 N.m (33 lb ft)

Driver or Passenger Seat Back Cushion Frame

Procedure

Disconnect and reposition harness as necessary.
Transfer components as necessary.