Installation Procedure
WARNING: This page is about a different car, the 2022 Cadillac CT5. However, it is still accessible from the selected car via links, so may be relevant.
Front Bumper Impact Bar (2) - Install
- Front Bumper Impact Bar Bolt (1) - Install and tighten [8x] - Fastener Specifications
- Install the wiring harness.
- NOTE:
Left side shown, right side similar.
Horn- Left Side and Right Side (2) - Install [2x]
- Horn Bolt- Left Side and Right Side (1) - Install and tighten [2x] - Fastener Specifications
- NOTE:
Left side shown, right side similar.
Transmission Fluid Auxiliary Cooler Bracket Bolt- Left Side and Right Side (2) - Install and tighten [2x] - Fastener Specifications
- Auxiliary Radiator Front Inlet Duct- Left Side and Right Side (1) - Install [2x]
{ If equipped }Forward Range Radar Bracket (2) - Install
- { If equipped }Forward Range Radar Bracket Bolt (1) - Install and tighten [3x] - Fastener Specifications
- { If equipped }Connect the electrical connector.
Front Bumper Fascia (1) - Install - Front Bumper Fascia Replacement (with Blackwing)
CAUTION:
Refer to Fastener Caution .