Knock Sensor 1 Replacement
WARNING: This page is about a different car, the 2022 Cadillac CT5. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Callouts in the following chart represent components shown in graphic above.
| Callout | Component Name |
|---|---|
| Preliminary Procedure Raise and support the vehicle. Lifting and Jacking the Vehicle |
|
| 1 | Knock Sensor Shield Bolt
CAUTION:
Refer to Fastener Caution . Tighten 25 N.m (18 lb ft) |
| 2 | Knock Sensor Shield |
| 3 | Knock Sensor Bolt Tighten 25 N.m (18 lb ft) |
| 4 | Knock Sensor Procedure Disconnect the electrical wiring harness connector from the knock sensor. |