Installation Procedure
WARNING: This page is about a different car, the 2022 Cadillac CT5. However, it is still accessible from the selected car via links, so may be relevant.
- NOTE:
Ensure that the fuel rail threads have been cleaned of any excess fuel or the fuel rail fuel pressure sensor will NOT seal properly.
Lubricate the threads and the sealing area in the fuel rail with silicon free engine oil. Adhesives, Fluids, Lubricants, and Sealers
- Lubricate the threads and the sealing area on the fuel rail fuel pressure sensor with silicon free engine oil. Adhesives, Fluids, Lubricants, and Sealers
- Fuel Injection Fuel Rail Fuel Pressure Sensor (1) - Install and tighten33 N.m (25 lb ft)
- Electrical Connector (3) @Fuel Injection Fuel Rail Fuel Pressure Sensor - Connect
- Cable Tie (2) @Fuel Injection Fuel Rail Fuel Pressure Sensor - Install NEW
Intake Manifold (2) - Install - Intake Manifold Replacement
CAUTION:
Refer to Fastener Caution .
NOTE:
Applying force to the plastic housing of the sensor will destroy the sensor. To tighten or loosen, only apply force to the attached hexagon.