Camshaft Position Sensor Replacement - Bank 2 (Left Side) Exhaust

WARNING: This page is about a different car, the 2022 Cadillac CT5. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of GENERAL MOTORS COMPANY

NOTE: Callouts in the following chart represent components shown in graphic above.

Callout	Component Name
Preliminary Procedure Intake Manifold Cover Replacement
1	Camshaft Position Sensor Bolt CAUTION: Refer to Fastener Caution . Tighten 10 N.m (89 lb in)
2	Camshaft Position Sensor Procedure Disconnect electrical connector and reposition wiring harness. Lubricate the O-ring seal with clean engine oil.

Callout

Component Name

Preliminary Procedure
Intake Manifold Cover Replacement

Camshaft Position Sensor Bolt

CAUTION:

Refer to Fastener Caution .

Tighten
10 N.m (89 lb in)

Camshaft Position Sensor

Procedure

Disconnect electrical connector and reposition wiring harness.
Lubricate the O-ring seal with clean engine oil.