Exhaust Camshaft Profile Sleeve Position Sensor Replacement

WARNING: This page is about a different car, the 2022 Cadillac CT5. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of GENERAL MOTORS COMPANY

NOTE: Callouts in the following chart represent components shown in graphic above.

Callout	Component Name
Preliminary Procedures Intake Manifold Cover Replacement Disconnect and reposition the camshaft position actuator wiring harness connectors.
1	Camshaft Exhaust Lobe Sensor Bolt [2x] CAUTION: Refer to Fastener Caution . Tighten 8.5 N.m (75 lb in)
2	Camshaft Exhaust Lobe Sensor [2x] Procedure Disconnect the electrical connector.

Callout

Component Name

Preliminary Procedures

Intake Manifold Cover Replacement
Disconnect and reposition the camshaft position actuator wiring harness connectors.

Camshaft Exhaust Lobe Sensor Bolt [2x]

CAUTION:

Refer to Fastener Caution .

Tighten
8.5 N.m (75 lb in)

Camshaft Exhaust Lobe Sensor [2x]
Procedure
Disconnect the electrical connector.