Removal Procedure

WARNING: This page is about a different car, the 2022 Cadillac CT4. However, it is still accessible from the selected car via links, so may be relevant.

Apply the parking brake.
Place the transmission control in the Neutral position.

NOTE:

The transmission control lever boot and knob are replaced as an assembly.

Courtesy of GENERAL MOTORS COMPANY

Using a flat bladed trim tool, detach the manual transmission control lever boot (2) from the console.
Lift the manual transmission control lever boot (2) to access the manual transmission control lever knob bolt (3).
Remove the manual transmission control lever knob bolt (3), then lift off the manual transmission control lever boot and knob assembly (1, 2).
Courtesy of GENERAL MOTORS COMPANY

Using a flat-bladed plastic trim tool, release the retaining clips.
Reposition the front floor console trim plate (1) to access the electrical connector.
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Some components not shown for graphic clarity.

Disconnect the instrument panel harness connector (1) from the front floor console wiring harness extension harness.
Courtesy of GENERAL MOTORS COMPANY

Front Floor Console Trim Plate (1) - Remove
Courtesy of GENERAL MOTORS COMPANY

Using a flat-bladed plastic trim tool, release the retaining clips.
Reposition the component to access the electrical connectors.
Disconnect the electrical connectors.
Front Floor Console Rear Trim Panel (1) - Remove
Courtesy of GENERAL MOTORS COMPANY

Reposition the seat as necessary to access the retaining clips.
Using a flat-bladed plastic trim tool, release the retaining clips.
Front Floor Console Extension Panel - Right Side (1) - Remove
Courtesy of GENERAL MOTORS COMPANY

Reposition the seat as necessary to access the retaining clips.
Using a flat-bladed plastic trim tool, release the retaining clips.
Front Floor Console Extension Panel - Left Side (1) - Remove
Courtesy of GENERAL MOTORS COMPANY

Using a suitable plastic trim tool, release the retaining tabs.
Disconnect the electrical connectors.
Multimedia Receptacle (1) - Remove
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Quantity of clips and routing of the front floor console wiring harness may vary based on option content.

Release the wiring harness clips and connectors on the front floor console wiring harness (1).
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Quantity of clips and routing of the front floor console wiring harness may vary based on option content.

Release the wiring harness clips on the front floor console wiring harness (1).
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Quantity of clips and routing of the front floor console wiring harness may vary based on option content.

Release the wiring harness clips and connectors and remove the front floor console wiring harness (1) from the front floor console.