Removal Procedure
WARNING: This page is about a different car, the 2022 Cadillac CT5. However, it is still accessible from the selected car via links, so may be relevant.
- Raise and support the vehicle. Lifting and Jacking the Vehicle
- Remove the left front tire and wheel assembly. Tire and Wheel Removal and Installation (without J57) , or Tire and Wheel Removal and Installation (with J57)
- Engine Front Splash Shield - Remove - Engine Front Splash Shield Replacement (AWD) , or Engine Front Splash Shield Replacement (RWD)
- Have an assistant apply the brakes.
- CAUTION:
DO NOT use air tools to remove the wheel drive shaft nut. Damage to the wheel drive shaft threads could occur. Use hand tools only.
Front Wheel Drive Shaft Nut (1) - Remove and DISCARD
Install the DT-45859 Axle Remover (1) to the front wheel hub and secure with 3 wheel nuts (2) hand tightened.
- Using the DT-45859 Axle Remover (1), release the front wheel drive half shaft from the front wheel hub.
- Remove the 3 wheel nuts (2) and the DT-45859 Axle Remover (1) from the front wheel hub.
- Front Suspension Strut @ Steering Knuckle - Separate - Strut Assembly Removal and Installation (FE2, FE3, witout F55) , or Strut Assembly Removal and Installation (FE3, FE4, with F55)
- Steering Linkage Outer Tie Rod @ Steering Knuckle - Separate - Steering Linkage Outer Tie Rod Replacement (without Blackwing) , or Steering Linkage Outer Tie Rod Replacement (with Blackwing)
Install the DT-45341 Rear Wheel Drive Shaft Removal Tool (1), GE-47829 Slide Hammer Extension (3) and GE-02619-A Slide Hammer (4) to the front wheel drive half shaft (2).
- Release the front wheel drive half shaft (2) from the front wheel drive intermediate shaft.
- Remove the GE-02619-A Slide Hammer (4), GE-47829 Slide Hammer Extension (3) and DT-45341 Rear Wheel Drive Shaft Removal Tool (1) from the front wheel drive half shaft (2).
Front Wheel Drive Half Shaft (1) - Remove
Front Wheel Drive Intermediate Shaft Retaining Ring (2) - Remove and DISCARD
- Front Wheel Drive Intermediate Shaft Seal (1) - Remove and DISCARD