Component Testing

WARNING: This page is about a different car, the 2022 Cadillac CT5. However, it is still accessible from the selected car via links, so may be relevant.

Steering Column Tilt/Telescope Switch Test

Ignition OFF, disconnect the harness connector at the S71 Steering Column Tilt Wheel and Telescope Switch.
Test for infinite resistance between the ground terminal 1 and each signal terminal with the S71 Steering Column Tilt Wheel and Telescope Switch in the released position.
- If less than infinite resistance
  Replace the S71 Steering Column Tilt Wheel and Telescope Switch.
- Go to next step: If infinite resistance
Test for less than 2 Ω between the ground terminal 1 and each signal terminal with the S71 Steering Column Tilt Wheel and Telescope Switch in the pressed position.
- If 2 Ω or greater
  Replace the S71 Steering Column Tilt Wheel and Telescope Switch.
- Go to next step: If less than 2 Ω
All OK.

Steering Column Telescope Actuator Test

Ignition OFF, disconnect the X2 harness connector at the K99 Steering Column Tilt Wheel and Telescope Control Module.
Test for 1 - 2.5 Ω between terminal 1 and terminal 2.
- If not within the specified range
  Replace the M65 Steering Column Telescope Actuator.
- Go to next step: If within the specified range
All OK.

Steering Column Tilt Wheel Actuator Test

Ignition OFF, disconnect the X1 harness connector at the K99 Steering Column Tilt Wheel and Telescope Control Module.
Test for 1 - 2.5 Ω between terminal 1 and terminal 2.
- If not within the specified range
  Replace the M68 Steering Column Tilt Wheel Actuator.
- Go to next step: If within the specified range
All OK.