Installation Procedure
WARNING: This page is about a different car, the 2022 Cadillac CT5. However, it is still accessible from the selected car via links, so may be relevant.
Rear Suspension Upper Control Arm (1) - Install
- CAUTION:
This vehicle is equipped with torque-to-yield or single use fasteners. Install a NEW torque-to-yield or single use fastener when installing this component. Failure to replace the torque-to-yield or single use fastener could cause damage to the vehicle or component.
Rear Suspension Upper Control Arm Outer Bolt (3) - Install NEW
- Rear Suspension Upper Control Arm Outer Nut (1) - Install, but do NOT tighten
Rear Suspension Upper Control Arm Inner Bolt (1) - Install NEW
- Rear Suspension Upper Control Arm Inner Nut (2) - Install and tighten
- First Pass: 70 N.m (52 lb ft)
- Final Pass: 90 - 100 degrees
Rear Suspension Upper Control Arm Outer Nut (1) - Tighten
- First Pass: 70 N.m (52 lb ft)
- Final Pass: 90 - 100 degrees
- Rear Wheel Speed Sensor@Rear Suspension Upper Control Arm - Install - Rear Wheel Speed Sensor Replacement (J56, JL9) , or Rear Wheel Speed Sensor Replacement (J57, J6H)
{If equipped} Position the rear brake line (2).
- {If equipped}Rear Brake Hose Clip Bolt (1) - Install and tighten [2x] - Fastener Specifications
- Install the rear tire and wheel assembly. Tire and Wheel Removal and Installation (without J57) , or Tire and Wheel Removal and Installation (with J57)
- Remove the support and lower the vehicle.
CAUTION:
Refer to Fastener Caution .