Removal Procedure

WARNING: This page is about a different car, the 2022 Cadillac CT5. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of GENERAL MOTORS COMPANY

Warm Up Three-Way Catalytic Converter - Right Side (1) - Remove - Warm Up Three-Way Catalytic Converter Replacement - Right Side (LGY)
Courtesy of GENERAL MOTORS COMPANY

Front Axle Propeller Shaft Heat Shield (3) - Remove - Front Axle Propeller Shaft Heat Shield Replacement (LGY)
Support the transmission with an appropriate jack.
Courtesy of GENERAL MOTORS COMPANY

Transmission Mount (2) - Remove - Transmission Mount Replacement (RWD) , or Transmission Mount Replacement (AWD)
Courtesy of GENERAL MOTORS COMPANY

Transfer Case Front Output Shaft Boot Clamp (1) @ Transfer Case Front Output Shaft - Remove and DISCARD
Release the transfer case front output shaft boot (2) from the groove in the transfer case front output shaft.
Courtesy of GENERAL MOTORS COMPANY

Mark the relationship between the front axle propeller shaft (2) and the front differential carrier flange with a grease pencil.
Front Axle Propeller Shaft Bolt (1) - Remove [6x]
Front Axle Propeller Shaft Washer (3) - Remove [3x]
Courtesy of GENERAL MOTORS COMPANY

Front Axle Propeller Shaft (1) - Remove
Courtesy of GENERAL MOTORS COMPANY

Inspect the transfer case front output shaft boot (1), if damage is found, remove and DISCARD the transfer case front output shaft boot clamp (2) and the transfer case front output shaft boot (1).