Installation Procedure

WARNING: This page is about a different car, the 2022 Cadillac CT5. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of GENERAL MOTORS COMPANY

Front Lower Control Rear Link (3) - Install

CAUTION:

This vehicle is equipped with torque-to-yield or single use fasteners. Install a NEW torque-to-yield or single use fastener when installing this component. Failure to replace the torque-to-yield or single use fastener could cause damage to the vehicle or component.

Front Lower Control Arm Rear Bolt (2) - Install NEW
Front Lower Control Arm Rear Nut (1) - Install, but do NOT tighten
Courtesy of GENERAL MOTORS COMPANY

CAUTION:
Refer to Fastener Caution .

NOTE:
Do NOT allow the ball stud to rotate while tightening the nut.

Front Lower Control Arm Ball Stud Nut (1) - Install and tighten
1. First Pass:40 N.m (30 lb ft)
2. Final Pass:120 - 135 degrees
Courtesy of GENERAL MOTORS COMPANY

Front Lower Control Arm Rear Bolt (2) - Tighten
1. First Pass:100 N.m (74 lb ft)
2. Final Pass:90 - 105 degrees
Courtesy of GENERAL MOTORS COMPANY

Front Compartment Air Deflector (1) - Install - Front Compartment Air Deflector Replacement (AWD) , or Front Compartment Air Deflector Replacement (Blackwing)
Courtesy of GENERAL MOTORS COMPANY

Engine Front Splash Shield (3) - Install - Engine Front Splash Shield Replacement (AWD)
Install the front tire and wheel assembly. Tire and Wheel Removal and Installation (without J57) , or Tire and Wheel Removal and Installation (with J57)
Remove the support and lower the vehicle.