Installation Procedure
Front Lower Control Front Link (1) - Install
- CAUTION:
This vehicle is equipped with torque-to-yield or single use fasteners. Install a NEW torque-to-yield or single use fastener when installing this component. Failure to replace the torque-to-yield or single use fastener could cause damage to the vehicle or component.
Front Lower Control Arm Front Bolt (2) - Install NEW
- Front Lower Control Arm Front Nut (1) - Install, but do NOT tighten
- Front Lower Control Arm Front Bolt (2) - Tighten
- First Pass:100 N.m (74 lb ft)
- Final Pass:90 - 105 degrees
- NOTE:
Do NOT allow the ball stud to rotate while tightening the nut.
Front Lower Control Arm Ball Stud Nut (1) - Install and tighten
- First Pass:40 N.m (30 lb ft)
- Final Pass:120 - 135 degrees
{ If equipped }Front Brake Rotor Cooling Duct Deflector (1) - Install
{ If equipped }Front Brake Rotor Cooling Duct Deflector Bolt (1) - Install and tighten [3x] - Front Brake Rotor Cooling Duct Deflector Replacement
- If equipped, install the electronic suspension wheel front vertical accelerometer retainers to the front lower control front link. Electronic Suspension Wheel Front Vertical Accelerometer Replacement (FE2, FE3) , or Electronic Suspension Wheel Front Vertical Accelerometer Replacement (FE4)
Front Compartment Air Deflector (1) - Install - Front Compartment Air Deflector Replacement (RWD) , or Front Compartment Air Deflector Replacement (Blackwing)
Front Bumper Fascia Center Air Deflector (1) - Install - Front Bumper Fascia Center Air Deflector Replacement
- Install the front tire and wheel assembly. Tire and Wheel Removal and Installation (without J57) , or Tire and Wheel Removal and Installation (with J57)
- Remove the support and lower the vehicle.
Refer to Fastener Caution .