LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2021 >> CT4 Sport, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 27 (Supplemental Restraints System) >> Repair Instructions >> Steering Wheel Airbag Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2022 Cadillac CT4. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:

Refer to SIR Warning .

WARNING:

Refer to SIR Inflator Module Handling and Storage Warning .

WARNING:

After installation of the steering wheel airbag module to the steering wheel, slightly pull the module outward. If there is no give on the airbag module then it is secured correctly. If the airbag module is not fully attached personal injury could result.

  1. Disable the SIR system. SIR Disabling and Enabling 
  2. GM5421708Courtesy of GENERAL MOTORS COMPANY

    Use a flat bladed plastic trim tool to depress the steering wheel airbag access hole cover detents to remove the 2 covers (1).

  3. GM5443287Courtesy of GENERAL MOTORS COMPANY
  4. Steering Wheel Airbag Bolt (1) - Remove [2x]
  5. Release the connector position assurance (CPA) retainer.
  6. Disconnect the electrical connectors.
  7. Steering Wheel Airbag (2) - Remove
  8. Inflatable Restraint Module Handling and Scrapping 
scientia non olet · About LEMON Manuals