LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2021 >> CT4 Sport, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 27 (Supplemental Restraints System) >> Repair Instructions >> Steering Wheel Airbag Coil Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2022 Cadillac CT4. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:

Refer to SIR Warning .

WARNING:

After installation of the steering wheel airbag module to the steering wheel, slightly pull the module outward. If there is no give on the airbag module then it is secured correctly. If the airbag module is not fully attached personal injury could result.

  1. Disable the SIR system. SIR Disabling and Enabling 
  2. GM5421708Courtesy of GENERAL MOTORS COMPANY

    Use a flat bladed plastic trim tool to depress the steering wheel airbag access hole cover detents to remove the 2 steering wheel airbag access hole covers (1).

  3. Extend the steering column to its furthest point to allow the instrument panel steering column upper trim cover to clear the instrument panel.
  4. GM5422815Courtesy of GENERAL MOTORS COMPANY

    Using a small plastic trim tool, separate the instrument panel steering column upper trim cover (1) from the instrument panel steering column lower trim cover.

  5. Instrument Panel Steering Column Upper Trim Cover (1) - Reposition
  6. GM5730572Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Instrument panel steering column upper trim cover is removed for graphic clarity.

    Disconnect the electrical connector (1), if equipped.

  7. GM5441328Courtesy of GENERAL MOTORS COMPANY

    Rotate the steering wheel left and right to access the instrument panel steering column lower trim cover bolts (1).

  8. Instrument Panel Steering Column Lower Trim Cover Bolt (1) - Remove [3x]
  9. Instrument Panel Steering Column Lower Trim Cover (2) - Remove
  10. GM5443287Courtesy of GENERAL MOTORS COMPANY

    Steering Wheel Airbag Bolt (1) - Remove [2x]

  11. Release the connector position assurance (CPA) retainer.
  12. Disconnect the electrical connectors.
  13. Steering Wheel Airbag (2) - Remove
  14. GM5421652Courtesy of GENERAL MOTORS COMPANY

    Loosen the steering wheel bolt (1) so that 2 - 3 threads are engaged.

  15. Disconnect the electrical connector.
  16. Wiggle the steering wheel until the wheel disengages completely.
  17. Steering Wheel Bolt (1) - Remove
  18. Steering Wheel (2) - Remove
  19. GM5428791Courtesy of GENERAL MOTORS COMPANY

    Release the retaining tabs and remove the steering wheel airbag coil (1) from the steering column.

  20. Disconnect the electrical connector.