Circuit/System Verification
WARNING: This page is about a different car, the 2022 Cadillac CT4. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition On / Vehicle in Service Mode
- Verify the condition does not exist / Airbag Indicator flashing
- If the condition exists
Refer to: K36 Restraints Control Module: Programming and Setup
- Go to next step: If no condition exists
- If the condition exists
- Verify there are no DTCs set related to the following system/component K36 Restraints Control Module
- If a related DTC is set
- Go to next step: If a related DTC is not set
- Cycle ignition OFF, then ON, Vehicle in service mode.
Verify the Passenger Airbag indicator On and Off both illuminate for 5 seconds.
- If passenger airbag indicators do not Illuminate
Replace the component: A103 Roof Console.
- Go to next step: If the passenger airbag indicators illuminate
- If passenger airbag indicators do not Illuminate
- All OK