Installation Procedure
WARNING: This page is about a different car, the 2022 Cadillac CT5. However, it is still accessible from the selected car via links, so may be relevant.
Rear Brake Shield (1) - Install
- Rear Brake Shield Bolt (2) - Install and tighten [2x] 9 N.m (80 lb in)
- NOTE:
Typical rear rotor is shown, actual rotor will vary based on RPO.
Rear Brake Rotor (2) - Install - Rear Brake Rotor Replacement (J6H) , or Rear Brake Rotor Replacement (J57)
- Install the rear tire and wheel assembly. Tire and Wheel Removal and Installation (without J57) , or Tire and Wheel Removal and Installation (with J57)
- Remove the support and lower the vehicle.
- Connect the battery negative cable. Battery Negative Cable Disconnection and Connection
CAUTION: