Removal Procedure
WARNING: This page is about a different car, the 2022 Cadillac CT5. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect the battery negative cable. Battery Negative Cable Disconnection and Connection
- Raise and support the vehicle. Lifting and Jacking the Vehicle
- Install the disc brake rotor protectors and remove the tire and wheel assembly. Tire and Wheel Removal and Installation (with J57) .
Rear Disc Brake Pad Wear Sensor (1) @Rear Disc Brake Inner Pad - Remove
Rear Brake Hose Fitting (2) - Remove
- Rear Brake Hose Fitting Gasket (3) - Remove and DISCARD [2x]
- Rear Brake Hose (1) @Rear Brake Caliper - Remove
- Plug the rear brake hose outlet to prevent fluid loss and contamination.
Rear Brake Caliper Guide Pin (1) - Remove [2x]
- Rear Disc Brake Pad Spring (2) - Remove
Rear Brake Caliper Bracket Bolt (2) - Remove [2x]
- Rear Brake Caliper (1) - Remove
Rear Disc Brake Inner Pad (2) - Remove
- Rear Disc Brake Outer Pad (1) - Remove
CAUTION:
Disc brake rotor protectors MUST be installed prior to tire and wheel assembly removal to avoid ceramic brake rotor damage due to contact between the tire and wheel assembly and the rotor. If the ceramic brake rotor is damaged replacement may be required.