Installation Procedure

WARNING: This page is about a different car, the 2022 Cadillac CT5. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of GENERAL MOTORS COMPANY

Front Disc Brake Pad (1) - Install [2x] - Front Disc Brake Pads Replacement (J56)
Due to the unknown shelf life of the adhesive patch, prepare the brake caliper bracket bolts and the bracket threaded holes as follows:
1. Remove any loose cured adhesive from the external threads of the components using a lint free cloth.
2. Thread the cleaned components into the internal mating threads and remove to loosen trapped cured adhesive.
3. Apply thread locking adhesive to the external threads of the components. Adhesives, Fluids, Lubricants, and Sealers
4. Ensure there are no gaps in the thread locking adhesive once applied to the component.
Courtesy of GENERAL MOTORS COMPANY

Front Brake Caliper (1) - Install
Courtesy of GENERAL MOTORS COMPANY

CAUTION:
Fastener Caution

Front Brake Caliper Bolt (1) - Install and tighten [2x]
- First Pass: 150 N.m (111 lb ft)
- Final Pass: 15 - 30 degrees
Courtesy of GENERAL MOTORS COMPANY
Front Brake Hose (2) @Front Brake Caliper - Install - Front Brake Hose Replacement (J56)
{If equipped} Front Disc Brake Pad Wear Sensor - Install - Front Disc Brake Pad Wear Sensor Replacement (J57, J6H)
Connect the battery negative cable. Battery Negative Cable Disconnection and Connection
Bleed the brake system. Hydraulic Brake System Bleeding (J56)
Check for brake system leaks.
Install the front tire and wheel assembly. Tire and Wheel Removal and Installation (without J57)
Remove the support and lower the vehicle.