Installation Procedure
WARNING: This page is about a different car, the 2022 Cadillac CT5. However, it is still accessible from the selected car via links, so may be relevant.
Rear Brake Hose (1) - Install
Remove the plug from the rear brake caliper inlet.
- Rear Brake Hose Fitting Gasket (3) - Install NEW [2x]
- Rear Brake Hose (2) @ Rear Brake Caliper - Install
- Rear Brake Hose Fitting (1) - Install and tighten to 40 N.m (30 lb ft)
Remove the cap from the rear brake pipe outlet.
- Rear Brake Pipe Clip (3) - Install
- Rear Brake Pipe Nut (2) - Install and tighten to 18 N.m (13 lb ft)
- Rear Brake Hose Clip Bolt (1) - Install and tighten [2x] 9 N.m (80 lb in)
Rear Wheel Speed Sensor (4) @ Wiring Harness Retainer (4) - Install
- Wiring Harness Retainer (3) - Engage
- Rear Disc Brake Pad Wear Sensor (1) @ Wiring Harness Retainer (2) - Install
- Wiring Harness Retainer (2) - Engage
- Bleed the brake system. Hydraulic Brake System Bleeding (J57, J6H, JL9)
- Check for brake system leaks.
- Install the rear tire and wheel assembly. Tire and Wheel Removal and Installation (with J57)
- Remove the support and lower the vehicle.
CAUTION:
Refer to Fastener Caution .