Installation Procedure
WARNING: This page is about a different car, the 2022 Cadillac CT5. However, it is still accessible from the selected car via links, so may be relevant.
Maneuver the rear brake front pipe (3) into the vehicle.
- Remove the cap from the front brake pipe inlet.
- Front Brake Pipe Nut (1) - Install and tighten to 18 N.m (13 lb ft)
- Rear Brake Front Pipe (2) @ Front Brake Pipe Retainer (3) - Install
Rear Brake Front Pipe (2) @ Front Brake Pipe Retainer (1) - Install
- Rear Brake Front Pipe (2) @ Front Brake Pipe Retainer (3) - Install [2x]
- Front Brake Pipe Retainer (1) - Engage
Brake Master Cylinder (1) - Install - Brake Master Cylinder Replacement - With Power Brake Booster and Electronic Brake Control Module (without MJK) , or Brake Master Cylinder Replacement - With Power Brake Booster and Electronic Brake Control Module (with MJK)
CAUTION:
Refer to Fastener Caution .