Removal Procedure
WARNING: This page is about a different car, the 2022 Cadillac CT5. However, it is still accessible from the selected car via links, so may be relevant.
- Prepare the brake system control module for removal with Service Programming System (SPS) and follow the on-screen instructions.
- Disconnect the battery negative cable. Battery Negative Cable Disconnection and Connection
- Front End Sheet Metal Cross Brace - Remove - Front End Sheet Metal Cross Brace Replacement (Impact Bar Bracket) , or Front End Sheet Metal Cross Brace Replacement (Plenum without Blackwing) , or Front End Sheet Metal Cross Brace Replacement (Plenum with Blackwing)
Electrical Connector (1) @ Brake System Control Module - Disconnect
Electronic Brake Control Module Bolt (1) - Remove and DISCARD [4x]
- CAUTION:
When removing the Brake System Control Module (BSCM) from the Master Cylinder Assembly, ensure the valve coils in the (BSCM) clear the pins in the Master Cylinder Assembly. If the coils or pins are damaged the complete Master Cylinder Assembly will require replacement.
Brake System Control Module (1) - Remove