Removal Procedure
WARNING: This page is about a different car, the 2022 Cadillac CT5. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect the battery negative cable. Battery Negative Cable Disconnection and Connection
- Thoroughly clean the brake master cylinder reservoir and the brake master cylinder body to remove any dirt and debris.
- Using a suitable tool, remove and properly dispose of the brake fluid from the brake master cylinder reservoir.
- Front End Sheet Metal Cross Brace - Remove - Front End Sheet Metal Cross Brace Replacement (Impact Bar Bracket) , or Front End Sheet Metal Cross Brace Replacement (Plenum with Blackwing)
Electrical Connector (1) @ Brake Fluid Level Sensor - Disconnect
- Remove and properly dispose of the brake fluid in the master cylinder reservoir.
Using a suitable tool, remove the clutch master cylinder reservoir hose (1) from the master cylinder reservoir.
- Install a cap or plug to the exposed hose and clutch master cylinder fittings in order to prevent fluid loss and contamination.
Brake Master Cylinder Reservoir Bolt (2) - Remove and DISCARD
- Lift the front of the brake master cylinder reservoir (1) upwards and remove from the brake master cylinder.
Brake Master Cylinder Reservoir Grommet (1) - Remove and DISCARD [3x]