Fastener Specifications
WARNING: This page is about a different car, the 2022 Cadillac CT5. However, it is still accessible from the selected car via links, so may be relevant.
Single Use Non-Threaded Fasteners/Components
|
NOTE:
All fasteners/components listed in this table MUST BE DISCARDED and replaced with NEW after removal. |
|---|
| Application |
| Air Conditioning Compressor and Condenser Hose Seal |
| Air Conditioning Compressor Hose Seal |
| Air Conditioning Condenser Hose Seal |
| Air Conditioning Evaporator Inlet Tube Seal |
| Air Conditioning Evaporator Outlet Tube Seal |
| Air Conditioning O-Ring Seal |
| Air Conditioning Sealing Washer |
Reusable Threaded Fastener Tightening Specifications
|
NOTE:
All fasteners listed in this table can be reused after removal. |
|
|---|---|
| Application | Specification |
| Metric (English) | |
| Air Conditioning Compressor and Condenser Hose Nut | 22 N.m (16 lb ft) |
| Air Conditioning Compressor Bracket Bolt | 4.4 N.m (39 lb in) |
| Air Conditioning Compressor Clutch Drive Plate | 35 N.m (26 lb ft) |
| Air Conditioning Compressor Clutch Pulley Bolt | 18 N.m (13 lb ft) |
| Air Conditioning Compressor Bolt (LSY, LGY) | 22 N.m (16 lb ft) |
| Air Conditioning Compressor Bolt (LT4) | 25 N.m (18 lb ft) |
| Air Conditioning Compressor Hose Bolt | 22 N.m (16 lb ft) |
| Air Conditioning Compressor Hose Nut | 22 N.m (16 lb ft) |
| Air Conditioning Compressor Nut | 22 N.m (16 lb ft) |
| Air Conditioning Compressor Stud | 9 N.m (80 lb in) |
| Air Conditioning Condenser Bolt | 6 N.m (53 lb in) |
| Air Conditioning Condenser Bracket Bolt | 6 N.m (53 lb in) |
| Air Conditioning Condenser Hose Nut | 22 N.m (16 lb ft) |
| Air Conditioning Condenser Tube Bolt | 6 N.m (53 lb in) |
| Air Conditioning Evaporator Hose Clip Nut | 9 N.m (80 lb in) |
| Air Conditioning Evaporator Thermal Expansion Valve Bolt | 7.4 N.m (65 lb in) |
| Air Conditioning Evaporator Thermal Expansion Valve Hose Nut | 22 N.m (16 lb ft) |
| Air Conditioning Evaporator Thermal Expansion Valve Stud | 9 N.m (80 lb in) |
| Air Conditioning Evaporator Tube Clip Bracket Bolt | 9 N.m (80 lb in) |
| Air Conditioning Receiver and Dehydrator | 12 N.m (106 lb in) |
| Air Conditioning Receiver and Dehydrator Plug | 7 N.m (62 lb in) |
| Air Conditioning Refrigerant High Pressure Service Valve | 2 N.m (18 lb in) |
| Air Conditioning Refrigerant Pressure Sensor | 7.5 N.m (66 lb in) |
| Charge Port Caps | 1.3 N.m (12 lb in) |
| Engine Wiring Harness Bolt | 22 N.m (16 lb ft) |
| Floor Front Air Outlet Duct Bolt | 2.5 N.m (22 lb in) |
| Heater and Air Conditioning Evaporator and Blower Upper and Blow Lower Case Bolt - Hex @ Cowl Panel | 9 N.m (80 lb in) |
| Heater and Air Conditioning Evaporator and Blower Upper and Blow Lower Case Bolt - Torx | 1.5 N.m (13 lb in) |
| Heater Hose Clip Bracket Bolt | 9 N.m (80 lb in) |
| Heater Water Auxiliary Pump Bolt | 9 N.m (80 lb in) |
| Instrument Panel Center Air Outlet Bolt | 2.5 N.m (22 lb in) |
| Instrument Panel Center Air Outlet Duct Bolt - Torx | 1.5 N.m (13 lb in) |
| Instrument Panel Center Air Outlet Duct Bolt | 2.5 N.m (22 lb in) |
| Service Port Cap | 1.3 N.m (12 lb in) |
| Side Window Defogger Outlet Bolt | 2.5 N.m (22 lb in) |
| Valve Core | .9 N.m (8 lb in) |