Removal Procedure
WARNING: This page is about a different car, the 2022 Cadillac CT5. However, it is still accessible from the selected car via links, so may be relevant.
Remove the catalytic converter brace bracket (3). Catalytic Converter Brace Bracket Replacement (LT4)
- Support the transmission using a suitable transmission jack.
- Disconnect the transmission control from the transmission. Manual Transmission Control Replacement
- Disconnect the wiring harness clips from the transmission.
Transmission Fluid Cooler Pipe Bolt (4) - Remove
- Transmission Fluid Cooler Pipe Bracket Bolt (3) - Remove
- Transmission Fluid Auxiliary Cooler Outlet PipeRetainer Clip (1) - Disengage [2x]
- Transmission Fluid Cooler Pipe - (2) Disconnect
- Transmission Fluid Cooler Pipe - (2) Remove
Disconnect the electrical connectors. (1, 2, 3, 4)
- Disconnect the wiring harness clips (5) from the transmission.
Remove the clutch actuator cylinder pipe retaining clip (1) from the clutch master cylinder pipe.
- Disconnect the clutch actuator cylinder pipe (3) from the clutch master cylinder pipe.
- Cap the opening to prevent contamination.
Remove the transmission bolt (1, 2).
Disconnect the wiring harness retainers (1) from the transmission clutch housing.
Remove the two transmission bolts and two transmission studs (1).
- Disconnect the intermediate steering shaft from the mid intermediate steering shaft. Mid Intermediate Steering Shaft Replacement (AWD)Mid Intermediate Steering Shaft Replacement (RWD)
- Front Wheelhouse Liner- Left Side and Right Side - Remove - Front Wheelhouse Liner ReplacementFront Wheelhouse Liner Replacement (Blackwing)
- Support the transmission with a suitable transmission jack.
- Loosen the four front cradle bolts (1), and remove the four rear cradle bolts (2) to allow the rear of the cradle support to tilt down with the jack approximately 125 mm (5 in). Drivetrain and Front Suspension Cradle Removal and Installation (RWD LSY)Drivetrain and Front Suspension Cradle Removal and Installation (AWD LSY)Drivetrain and Front Suspension Cradle Removal and Installation (Blackwing)Drivetrain and Front Suspension Cradle Removal and Installation (RWD LGY)Drivetrain and Front Suspension Cradle Removal and Installation (AWD LGY)
Remove the left side transmission bolt (1).
Remove the right side transmission stud (1).
- Remove the transmission from the vehicle. To clear the body structure, the front of the engine can be pushed up to tilt the engine and transmission.
- Inspect the transmission fluid cooler, hoses, and pipes for leaks or damage. Replace as necessary.
NOTE:
Do not leave the engine tilted on its mounts for an extended amount of time.