Torque Converter Removal and Holding Fixture Installation
WARNING: This page is about a different car, the 2022 Cadillac CT4. However, it is still accessible from the selected car via links, so may be relevant.
Special Tools
- DT-03289-20 Holding Fixture Base Assembly
- DT-48989 Holding Fixture
Equivalent regional tools: Special Tools
Attach and secure DT-48989 Holding Fixture (2) to the Automatic Transmission Case (4).
- Support the transmission with an overhead hoist attached to DT-48989 Holding Fixture (2).
- Install DT-48989 Holding Fixture (2) with the Automatic Transmission Case (4) into the DT-03289-20 Holding Fixture Base Assembly (1)
- Rotate the transmission so that the converter housing is up and secure with DT-03289-20 Holding Fixture Base Assembly (1) locking pin.
- Allow any remaining transmission fluid to drain from the case extension.
- Torque Converter (3) - Remove