Installation Procedure
Programmable Temperature Valve Actuator-Air Inlet Valve Actuator (1) - Install
- CAUTION:
Refer to Fastener Caution .
Heater and Air Conditioning Evaporator and Blower Upper and Blow Lower Case Bolt (1) - Install and tighten - Fastener Specifications
Heater and Air Conditioning Evaporator and Blower Upper and Blow Lower Case Bolt (2) - Install and tighten - Fastener Specifications
- Connect the electrical connector. (1)
- Connect the electrical connectors at the instrument panel compartment.
Instrument Panel Compartment (1) - Install
Instrument Panel Compartment Bolt (1) - Install and tighten [5x] - Fastener Specifications
Connect the instrument panel lower airbag electrical connector.
- Instrument Panel Lower Airbag - Passenger Side (2) - Install
- Instrument Panel Lower Airbag Nut (1) - Install and tighten [2x] - Fastener Specifications
{ If equipped } Connect the electrical connector.
- Instrument Panel Outer Trim Cover - Right Side (1) - Install
Engage the instrument panel lower trim panel insulator into the front of the front floor console extension panel.
- Instrument Panel Lower Trim Panel Insulator - Right Side (1) - Install
Connect the body control module connectors (3).
- Body Control Module (4) - Install
- Attach the wiring harness clips (1) onto the body control module bracket.
- Install the detent (2) onto the instrument panel lower trim panel insulator.
Instrument Panel Insulator Bolt (1) - Install and tighten [4x] - Fastener Specifications
Lock the body control module bracket (2) to the instrument panel lower trim panel insulator.
- Body Control Module Bracket Bolt (1) - Install and tighten - Fastener Specifications
- Enable the SIR System. SIR Disabling and Enabling