LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2021 >> CT4 Sport, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 228 (Vehicle Access System - Diagnostic Information And Procedures) >> Diagnostic Information and Procedures >> DTC B11A4, B11A5, or B1802 >> Component Testing

Component Testing

WARNING: This page is about a different car, the 2022 Cadillac CT4. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition/Vehicle - Off
  2. Disconnect the electrical connector: A23RR Rear Side Door Latch - Right
  3. Connect a 25 A fused jumper wire between the test points: Control terminal 9 & B+
    4. CAUTION:

    Complete the testing as quickly as possible in order to prevent overheating and damaging the component.

  4. Momentarily connect a jumper wire between the test points: Control terminal 8 & Ground
  5. Reverse the jumper wires 2 times between the terminals.

    Verify the component works as specified: A23RR Rear Side Door Latch - Right = Lock & Unlock

    • If not the specified state 

      Replace the component: A23RR Rear Side Door Latch - Right

    • Go to next step: If the specified state 
  6. All OK.
scientia non olet · About LEMON Manuals