LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2021 >> CT4 Sport, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 228 (Vehicle Access System - Diagnostic Information And Procedures) >> Diagnostic Information and Procedures >> DTC B10CB or B10CC >> Component Testing

Component Testing

WARNING: This page is about a different car, the 2022 Cadillac CT4. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition/Vehicle - Off
  2. Disconnect the appropriate electrical connector:
    • A24D Front Side Door Outside Handle - Left
    • A24P Front Side Door Outside Handle - Right
  3. Test for infinite resistance between the test points: Signal terminal 1 & Ground terminal 5 - Not Pressed
    • If less than infinite resistance 

      Replace the component:

    • A24D Front Side Door Outside Handle - Left
    • A24P Front Side Door Outside Handle - Right
    • Go to next step: If infinite resistance 
  4. Test for less than 3 ohms between the test points: Signal terminal 1 & Ground terminal 5 - Pressed
    • If 3 ohms or greater 

      Replace the component:

    • A24D Front Side Door Outside Handle - Left
    • A24P Front Side Door Outside Handle - Right
    • Go to next step: If less than 3 ohms 
  5. All OK.
scientia non olet · About LEMON Manuals