LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2021 >> CT4 Sport, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 224 (Lighting System - Diagnostic Information And Procedures (1 Of 2)) >> Diagnostic Information and Procedures >> DTC B195A >> Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different car, the 2022 Cadillac CT4. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition/vehicle OFF, disconnect the connector at the B10B Sun Load Temperature and Ambient Light and Security Indicator Sensor.
  2. Ignition on/vehicle in service mode, verify a test lamp illuminates between low reference terminal 6 and B+.
    • If the test lamp does not illuminate 
    1. Test circuit 407 for an open/high resistance.
      • If an open/high resistance is found, repair the fault on the circuit.
      • Go to next step: If an open/high resistance is not found.
    2. Replace the K9 Body Control Module.
    • Go to next step: If the test lamp illuminates 
  3. Test for 4.8 V - 5.2 V between signal circuit terminal 3 and ground.
    • If less than 4.8 V 
    1. Test circuit 278 for a short to ground.
      • If a short to ground is found, repair the fault on the circuit.
      • Go to next step: If a short to ground is not found.
    2. Test circuit 278 for an open/high resistance.
      • If an open/high resistance is found, repair the fault on the circuit.
      • Go to next step: If an open/high resistance is not found.
    3. Replace the K9 Body Control Module.
    • Go to next step: If greater than 5.2 V 
    1. Test circuit 278 for a short to voltage.
      • If a short to voltage is found, repair the fault on the circuit.
      • Go to next step: If a short to voltage is not found.
    2. Replace the K9 Body Control Module.
    • Go to next step: If between 4.8 V - 5.2 V 
  4. Replace the B10B Sun Load Temperature and Ambient Light and Security Indicator Sensor.
scientia non olet · About LEMON Manuals