Removal Procedure

WARNING: This page is about a different car, the 2022 Cadillac CT4. However, it is still accessible from the selected car via links, so may be relevant.

Disconnect the battery. Battery Negative Cable Disconnection and Connection
Wiring Harness Retainer (1) @ Air Cleaner Assembly - Remove [4x]
Positive Crankcase Ventilation Tube (2) - Disconnect - Plastic Collar Quick Connect Fitting Service
Evaporative Emission Canister Purge Tube (3) - Disconnect - Plastic Collar Quick Connect Fitting Service
Electrical Connector (4) - Disconnect [2x]
Air Cleaner Bolt (1) - Remove
Air Cleaner Outlet Duct Clamp (2) - Loosen
Remove the air cleaner (1) and air cleaner outlet duct (2) as an assembly.
Turbocharger Heat Shield Bolt (1) - Remove [3x]
Turbocharger Heat Shield (1) - Remove
Water Pump Cover Bolt (1) - Remove [2x]
Water Pump Cover (2) - Remove
Engine Mount Nut (1) - Remove
Engine Mount Bracket Bolt (1) - Remove and DISCARD [4x]
Retainer Spring (1) - Release
Charge Air Cooler Inlet Air Tube (2) @ Compressor Air Intake Turbocharger (3) - Reposition
Remove harness retainer.
Engine Mount Bracket (1) - Remove

CAUTION:

Phenolic spacer must be present to prevent galvanic/corrosive reaction and/or excessive temperature conduction between engine mount bracket and engine mount. Replace mount if phenolic spacer is missing or damaged. Failure to ensure phenolic spacer is intact and not damaged can lead to premature failure of engine mount and/or engine mount bracket.

Ensure the phenolic spacer remains in place.