LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2021 >> CT4 Sport, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 220 (Engine Mechanical - 2.0L (LSY) - Repair Instructions (1 Of 3)) >> Repair Instructions >> Crankshaft Balancer Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2022 Cadillac CT4. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the battery. Battery Negative Cable Disconnection and Connection
  2. Remove the oil fill cap.
  3. GM5335087

    Lift up on the front of the intake manifold cover (1).

  4. GM5335089

    Intake Manifold Cover (1) @ Upper Intake Manifold Bracket (2) - Remove

  5. GM5129599

    Using an appropriate tool, rotate the drive belt tensioner (1) counterclockwise and hold tension.

  6. GM5129786

    Accessory Drive Primary Belt (1) - Remove

  7. Slowly release tension on the drive belt tensioner.
  8. GM5335764

    Oil Level Indicator (1) - Remove

  9. GM5136547

    Electrical Connector (1) @ Oil Level Indicator Tube (3) - Unclip

  10. Oil Level Indicator Tube Bracket Bolt (2) - Remove
  11. GM5068106

    Oil Level Indicator Tube (1) - Remove

  12. Oil Level Indicator Tube Seal (2) - Remove and DISCARD
  13. Raise and support the vehicle. Lifting and Jacking the Vehicle
  14. GM5460874

    Battery Negative Cable Nut (1) @ Starter Stud - Remove

  15. Engine Wiring Harness Retainer (2) - Disengage [2x]
  16. Auxiliary Generator Battery Jumper Cable (3) - Remove
  17. GM5460935

    Electrical Connector (1) - Disconnect

  18. GM5460947

    Battery Positive Cable Nut (1) @ Starter Solenoid - Remove

  19. Auxiliary Generator Battery Jumper Cable (2) - Remove
  20. GM5319715

    Starter Stud (1) - Remove

  21. Starter Bolt (2) - Remove [2x]
  22. Starter (3) - Remove
  23. GM5164169
    NOTE:

    The timing pin (3) is installed into the flexplate for engine timing procedures, it can be damaged if torque is applied to the flexplate with the timing pin engaged. The timing pin must be placed in the retracted position using the handle (1) and twisting to locked position. The slide part (4) to be installed to the flex plate when torque is applied to the flexplate or crankshaft balancer bolt.

    Install the EN-52476  Flywheel Lock and Alignment Tool (2) through the starter mounting hole.

  24. Lower the vehicle.
  25. GM4998850

    Crankshaft Balancer Bolt (1) - Remove and DISCARD

  26. Crankshaft Balancer (2) - Remove
scientia non olet · About LEMON Manuals