Circuit/System Testing
WARNING: This page is about a different car, the 2022 Cadillac CT4. However, it is still accessible from the selected car via links, so may be relevant.
Power Sunroof Malfunction
- Ignition/vehicle OFF, disconnect the harness connector at the K61 Sunroof Control Module
- Verify a test lamp illuminates between ground circuit terminal 1 and B+.
- If the test lamp does not illuminate
- Repair the open/high resistance on circuit 2350 or ground connection.
- Go to next step: If the test lamp illuminates
- Ignition ON/vehicle in service mode, verify a test lamp illuminates between B+ circuit terminal 6 and ground.
- If the test lamp does not illuminate and the circuit fuse is OK
- Test circuit 3540 for an open/high resistance.
- If an open/high resistance is found, repair the fault on the circuit.
- If an open/high resistance is not found, verify there is voltage at the fuse.
- If the test lamp does not illuminate and the circuit fuse is open
- Test circuit 3540 for a short to ground.
- If a short to ground is found, repair the fault on the circuit.
- Go to next step: If a short to ground is not found.
- Replace the K61 Sunroof Control Module
- Go to next step: If the test lamp Illuminates
- Replace the K61 Sunroof Control Module