LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2021 >> CT4 Sport, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 21 (Wiring Systems And Power Management - Diagnostic Information And Procedures) >> Diagnostic Information and Procedures >> Power Mode Mismatch >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different car, the 2022 Cadillac CT4. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition ON.
  2. Open the drivers door.
  3. Verify that the KR76 Accessory Time Delay Cutoff Relay cycles on and off while switching the ignition between Run Mode and Off, by verifying a click is heard and/or felt.
    • If a click is not heard and/or felt 

      Refer to Circuit/System Testing - KR76 Accessory Time Delay Cutoff Relay

    • Go to next step: If a click is heard and/or felt 
    4. NOTE:

    Use Wiring Schematics to determine the appropriate devices controlled by the KR76 Accessory Time Delay Cutoff Relay.

  4. Open the drivers door.
  5. Verify that the appropriate devices controlled by the KR76 Accessory Time Delay Cutoff Relay turn ON and OFF when cycling the ignition between Run mode and OFF.
    • Go to next step: If the devices do not turn ON and OFF 

      Go to next step: Refer to: The appropriate diagnosis for your device (s) that are inoperative.

    • Go to next step: If the devices turn ON and OFF 
  6. Verify that the KR73 Ignition Main Relay cycles on and off while switching the ignition between Run Mode and Off, by verifying a click is heard and/or felt.
    • If a click is not heard and/or felt 

      Refer to Circuit/System Testing - KR73 Ignition Main Relay

    • Go to next step: If a click is heard and/or felt 
    7. NOTE:

    Use Wiring Schematics to determine the appropriate devices controlled by the KR73 Ignition Main Relay.

  7. Open the drivers door.
  8. Verify that the appropriate devices controlled by the KR73 Ignition Main Relay turn ON and OFF when cycling the ignition between Run and OFF.
    • If the devices do not turn ON and OFF 

      Refer to: The appropriate diagnosis for your device (s) that are inoperative.

    • Go to next step: If the devices turn ON and OFF 
  9. A fault is not currently present and may be an intermittent condition.
scientia non olet · About LEMON Manuals