LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2021 >> CT4 Sport, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 198 (Engine Mechanical - 3.6L (LF4) - Repair Instructions (3 Of 4)) >> Repair Instructions >> Crankshaft Rear Oil Seal and Housing Replacement (with MG9) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2022 Cadillac CT4. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the manual transmission from the vehicle. Manual Transmission Removal and Installation
  2. GM71490
    NOTE:
    • If reusing the pressure plate assembly, place an alignment mark on the pressure plate and flywheel for proper alignment during installation.
    • DO NOT use air tools to remove the clutch pressure plate bolts

    Loosen the clutch pressure plate bolts using the following sequence:

    1. Loosen bolts 1 and 2 one full turn, then stop.
    2. Loosen bolts 3 and 4 one full turn, then stop.
    3. Loosen bolts 5 and 6 one full turn, then stop.
    4. Repeat Steps 4.1 through 4.3 until all bolts are loose.
  3. GM5911346

    Clutch Pressure Plate Bolt (1) - Remove and DISCARD [6x]

  4. Remove the clutch pressure plate (2) from the dowel pins on the flywheel.
  5. Remove the driven disc (3).
  6. GM5906814

    Oil Pan Bolt (3) - Remove [2x]

  7. Crankshaft Rear Oil Seal Housing Bolt (1) - Remove [5x]
  8. Crankshaft Rear Oil Seal Housing (2) - Remove and DISCARD
scientia non olet · About LEMON Manuals