Installation Procedure
Oil Pump Suction Pipe Gasket (3) - Install NEW
- Oil Pump Suction Pipe (2) - Install
- Oil Pump Suction Pipe Bolt (1) - Install and tighten - Fastener Specifications
Wipe the oil pan surface with the Adhesion Plastic Pan Primer Promoter using a clean shop towel. Allow the cleaner to flash / evaporate. Wipe off the sealing surfaces with a lint free cloth. Do not touch the sealing surface after cleaning to avoid inducing containment debris to the bonding surface area. Adhesives, Fluids, Lubricants, and Sealers
- Ensure proper use of room temperature vulcanizing (RTV) sealant. Use of Room Temperature Vulcanizing (RTV) and Anaerobic Sealant
- Apply a 3 mm (0.12 in) bead of sealant (1) around the seal bead path, as shown.
- NOTE:
Use the front cradle to rest the oil pan on while feeding the EN-52483 Cover Installation Guide Pins through the oil pan bolt holes in two locations to keep oil pan square and aid in alignment.
Install EN-52483 Guide Pins (1) in two locations to keep oil pan square and aid in alignment.
Oil Pan (2) - Install NEW
- Lower Oil Pan Bolt (1) - Install and hand tighten [4x]
- EN-52483 Cover Installation Guide Pins - Remove [2x]
- Lower Oil Pan Bolt (1) - Install and hand tighten [13x]
- Lower Oil Pan Bolt (1) - Tighten in sequence [17x] - Fastener Specifications
- Fill the engine oil to the proper level with NEW engine oil. Engine Oil and Oil Filter Replacement (RWD)
Refer to Fastener Caution .
Do not allow sealant to skim over, the oil pan must be installed within 8 minutes of sealer application.
Install some lower oil pan bolts to secure the oil pan.