LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2021 >> CT4 Sport, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 170 (Engine Mechanical - 2.7L (L3B) - Repair Instructions (2 Of 3)) >> Repair Instructions >> Oil Pan Replacement (AWD) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2022 Cadillac CT4. However, it is still accessible from the selected car via links, so may be relevant.
  1. GM5389826

    Wipe the oil pan surface with the Adhesion Plastic Pan Primer Promoter using a clean shop towel. Allow the cleaner to flash / evaporate. Wipe off the sealing surfaces with a lint free cloth. Do not touch the sealing surface after cleaning to avoid inducing containment debris to the bonding surface area. Adhesives, Fluids, Lubricants, and Sealers

  2. Ensure proper use of room temperature vulcanizing (RTV) sealant. Use of Room Temperature Vulcanizing (RTV) and Anaerobic Sealant
    3. NOTE:

    Do not allow sealant to skim over, the oil pan must be installed within 8 minutes of sealer application.

  3. Apply a 3 mm bead of sealant (1) around the seal bead path, as shown.
  4. GM5389827

    Install EN-52483  Guide Pin in two locations to keep oil pan square and aid in alignment.

  5. Oil Pan (2) - Install NEW
    6. NOTE:

    Install some lower oil pan bolts to secure the oil pan.

  6. Lower Oil Pan Bolt (1) - Install and hand tighten [4x]
  7. EN-52483  Guide Pins - Remove [2x]
    8. NOTE:

    Install the remaining lower oil pan bolts.

  8. Lower Oil Pan Bolt (1) - Install and hand tighten [13x]
  9. Lower Oil Pan Bolt (1) - Tighten in sequence [17x] - Fastener Specifications
  10. Lower the vehicle. Lifting and Jacking the Vehicle
  11. Fill the engine oil to the proper level with NEW engine oil. Engine Oil and Oil Filter Replacement (RWD) 
  12. Connect the battery negative cable. Battery Negative Cable Disconnection and Connection
scientia non olet · About LEMON Manuals