Circuit/System Verification
WARNING: This page is about a different car, the 2022 Cadillac CT4. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition - On / Vehicle - In Service Mode
- Verify DTC P1248 - P124B is not set and no other DTCs are set.
- If DTC P1248 - P124B is not set and other DTCs are set
Refer to: Circuit/System Testing - Test 1
- If DTC P1248 - P124B is set and no other DTCs are set
Refer to: Circuit/System Testing - Test 2
- Go to next step: If no DTC is set
- If DTC P1248 - P124B is not set and other DTCs are set
- Engine - Running
- Verify the scan tool parameter: Cylinder 1 - 4 Current Misfire Counter = Does not Increment
Perform the action while monitoring the parameter:
Wiggle the harness and connector: K20 Engine Control Module
- If the parameter value increments
Repair as necessary - Wiring / Terminal (s) / Electrical Connector (s)
- Go to next step: If the parameter value does not increment
- If the parameter value increments
- Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
Verify the DTC does not set.
- If the DTC sets
Repeat step 2
- Go to next step: If the DTC is not set
- If the DTC sets
- All OK.
NOTE:
This step only applies to the following component DTCs: Q17 Fuel Injector