LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2021 >> CT4 Sport, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 165 (Engine Controls And Fuel - 2.7L (L3B) - Diagnostic Information And Procedures (1 Of 3)) >> Diagnostic Information and Procedures >> DTC P00C7 >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different car, the 2022 Cadillac CT4. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition - On / Vehicle - In Service Mode
  2. Verify DTC P0106, P0107, P0108, P2122, P2123, P2127, P2128, P2138, P2610 is not set.
    • Go to next step: If none of the DTCs are set 
  3. Verify the scan tool parameter: Throttle Body Idle Air Flow Compensation = Less than 90%
    • Go to next step: If less than 90% 
  4. Verify the following conditions do not exist:
    • B65 Manifold Absolute Pressure and Intake Air Temperature Sensor - Leaking @ O-Ring - Missing / Visible Damage
    • B75 Mass Airflow Sensor - Contamination of the measuring element /Cracked/Loose Clamps / Visible Damage/Water intrusion
    • B111 Turbocharger/Supercharger Boost Pressure Sensor
      • Leaking @ O-Ring - Missing / Visible Damage
      • Restricted - Moisture/Ice
      • Skewed
    • Q38 Throttle Body
      • Coking/Loose Clamps /Visible Damage
      • Restricted - Moisture/Ice
    • Air Cleaner Element - Dirty / Restricted
    • Catalytic Converter - Blocked / Restricted/Visible Damage
    • Charge Air Cooler
      • Leaking / Incorrect connection
      • Restricted - Moisture/Ice
    • Intake Air Duct - Cracked / Loose Clamps / Restricted / Visible Damage
    • Intake Manifold - Cracked / Loose Clamps / Restricted / Vacuum leak/Visible Damage
    • Positive Crankcase Ventilation System
      • Leaking @ O-Ring - Missing / Visible Damage
      • Restricted - Moisture/Ice
      • Incorrect connection /Leaking / Restricted
    • If a condition exists 

      Repair or replace as necessary

    • Go to next step: If no condition exists 
  5. Verify the scan tool parameter:
    • If not in the specified range 
    • Go to next step: If in the specified range 
  6. All OK.