LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2021 >> CT4 Sport, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 158 (Engine Mechanical - 2.7L (L3B) - Repair Instructions (1 Of 3)) >> Repair Instructions >> Balancer Shaft Driven Sprocket Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2022 Cadillac CT4. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the transmission. Transmission Replacement (All Wheel Drive) , or Transmission Replacement (Rear Wheel Drive)
  2. GM5150614

    Install the EN-52476  Flywheel Lock and Alignment Tool (1) through the starter mounting hole.

  3. GM5517309

    Automatic Transmission Flex Plate Bolt (1) - Remove and DISCARD [8x]

  4. Automatic Transmission Flex Plate (2) - Remove
  5. GM5140979
    CAUTION:

    Refer to Crankshaft Position Sensor Reluctor Ring Caution .

    Crankshaft Position Sensor Reluctor Ring (1) - Remove

  6. Flywheel Locating Pin (2) - Remove
  7. GM5511921

    Electrical Connector (1) - Disconnect

  8. GM5511922

    Crankshaft Position Sensor Bracket Bolt (1) - Remove

  9. Crankshaft Position Sensor (2) - Remove
  10. GM5004098

    Crankshaft Rear Oil Seal Housing Bolt (1) - Remove [14x]

  11. Crankshaft Rear Oil Seal Housing (2) - Remove and DISCARD
  12. GM5153596

    Compress the balancer chain tensioner (1).

  13. EN-52593  Chain Tensioner Retention Pin (2) - Install
  14. GM5153597

    Balancer Chain Tensioner Bolt (1) - Remove [2x]

  15. Balancer Chain Tensioner (2) - Remove
  16. GM5153224

    Balancer Shaft Sprocket Bolt (1) - Remove and DISCARD

  17. Balancer Shaft Driven Sprocket (2) - Remove
scientia non olet · About LEMON Manuals