LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2021 >> CT4 Sport, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 158 (Engine Mechanical - 2.7L (L3B) - Repair Instructions (1 Of 3)) >> Repair Instructions >> Balancer Chain Guide Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2022 Cadillac CT4. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the transmission. Transmission Replacement (All Wheel Drive) , or Transmission Replacement (Rear Wheel Drive)
  2. GM5150614
    NOTE:

    The timing pin (3) is installed into the flexplate for engine timing procedures, it can be damaged if torque is applied to the flexplate with the timing pin engaged. The pin must be placed in the retracted position before torque is applied to the flexplate.

    Install the EN-52476  Flywheel Lock and Alignment Tool (1) through the starter mounting hole.

  3. GM5517309

    Automatic Transmission Flex Plate Bolt (1) - Remove and DISCARD [8x]

  4. Automatic Transmission Flex Plate (2) - Remove
  5. GM5140979
    CAUTION:

    Refer to Crankshaft Position Sensor Reluctor Ring Caution .

    Crankshaft Position Sensor Reluctor Ring (1) - Remove

  6. Flywheel Locating Pin (2) - Remove
  7. GM5511921

    Electrical Connector (1) - Disconnect

  8. GM5511922

    Crankshaft Position Sensor Bracket Bolt (1) - Remove

  9. Crankshaft Position Sensor (2) - Remove
  10. GM5004098

    Crankshaft Rear Oil Seal Housing Bolt (1) - Remove [14x]

  11. Crankshaft Rear Oil Seal Housing (2) - Remove and DISCARD
  12. GM5153596

    Compress the balancer chain tensioner (1).

  13. EN-52593  Chain Tensioner Retention Pin (2) - Install
  14. GM5153495

    Timing Chain Guide Bolt (2) - Remove [2x]

  15. Balancer Chain Guide (3) - Remove
scientia non olet · About LEMON Manuals