Assemble Procedure

WARNING: This page is about a different car, the 2022 Cadillac CT4. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION:
Refer to Component Fastener Tightening Caution .

Balancer Shaft Bearing (6) - Install [5x]
Balancer Drive Shaft (5) - Install
NOTE:
Add engine oil to all bearings.
Balancer Driven Shaft (4) - Install
Balancer Shaft Bearing (3) - Install [5x]
Balancer Shaft Bearing Cap (2) - Install

CAUTION:

Refer to Fastener Caution .

Balancer Shaft Bearing Bolt (1) - Install and tighten - Fastener Specifications
NOTE:
Add engine oil to all bearings.

Balancer Shaft Front Bearing (1) - Install [4x]
Oil Pump Locating Pin (3) - Install [2x]
Oil Pump Seal (4) - Install NEW
Oil Pump Flow Control Solenoid Valve (2) - Install
Oil Pump Flow Control Solenoid Valve Bolt (1) - Install and tighten - Fastener Specifications
Oil Pump Gasket (1) - Install NEW
Oil Pump Drive Shaft (2) - Install
NOTE:
Do not apply pressure to oil pump drive shaft during install. Doing so can cause damage to internal teeth of the oil pump.
Oil Pump (5) @ Balancer Shaft Housing (4) - Install
Oil Pump Bolt (3) - Install [3x] - Fastener Specifications
Install the balancer shaft housing (1) along with the oil pump.
NOTE:
Mind the different bolt lengths.

Balancer Shaft Housing Bolt (1, 2) - Install and tighten in sequence [7x] - Fastener Specifications
CAUTION:
Refer to Component Fastener Tightening Caution .

Positive Crankcase Ventilation Oil Separator Drain Pipe (1) - Install and tighten - Fastener Specifications
Engine Oil Level Indicator Switch (3) - Install
Engine Oil Level Indicator Switch Bolt (2) - Install and tighten [2x] - Fastener Specifications
Engine Wiring Harness Clip (3) - Clip [2x]
Electrical Connector (2) @ Oil Pump Flow Control Solenoid Valve - Connect