Installation Procedure
WARNING: This page is about a different car, the 2022 Cadillac CT4. However, it is still accessible from the selected car via links, so may be relevant.
Rear Seat Belt Retractor (2) - Install
- Install and tighten the 2 upper rear seat belt retractor bolts (1). Fastener Specifications
Connect the electrical connector.
- Quarter Upper Trim Panel (3) - Install
- Quarter Window Trim Finish Panel Bolt (2) - Install and tighten - Fastener Specifications
- Quarter Window Trim Finish Panel Bolt Cap - Install
Install the rear seat belt retractor bolt at the rear seat belt anchor plate (1) on the side of the trim panel being replaced. Fastener Specifications
- Feed the rear seat belt retractor belt through the bezel opening in the quarter upper trim panel.
Rear Seat Back Bolster (2) - Install
- Rear Seat Back Bolster Nut (1) - Install and tighten - Fastener Specifications
Slide the rear seat back bolster retainer lock (1) toward the front of the vehicle.
Rear Seat Cushion (1) - Install - Rear Seat Cushion Removal and Installation
- Enable the SIR System. SIR Disabling and Enabling .
CAUTION:
Refer to Fastener Caution .