Installation Procedure

WARNING: This page is about a different car, the 2022 Cadillac CT4. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of GENERAL MOTORS COMPANY

Install the body wiring harness junction block to the rear body fuse block bracket (1).
Courtesy of GENERAL MOTORS COMPANY

Slide the electronic suspension control module (1) into the rear body fuse block bracket until the retaining tab (2) is engaged.
Courtesy of GENERAL MOTORS COMPANY

Rear Body Fuse Block Bracket (1) - Install
Courtesy of GENERAL MOTORS COMPANY

CAUTION:
Refer to Fastener Caution .

Body Wiring Harness Junction Block Bracket Nut (2) - Install and tighten [2x] - Fastener Specifications
Connect the wiring harness retainers to the bracket.
Connect the electrical connectors to the fuse block.
Courtesy of GENERAL MOTORS COMPANY

Install the 5 body wiring harness retainers (1).
Courtesy of GENERAL MOTORS COMPANY

Rear Compartment Side Trim-Left Side (2) - Install
Rear Compartment Side Trim Insulator Retainer (1) - Install [4x]
Courtesy of GENERAL MOTORS COMPANY

Rear End Trim Finish Panel (1) - Install
Courtesy of GENERAL MOTORS COMPANY

Rear End Trim Finish Panel Opening Cover (1) - Install
Courtesy of GENERAL MOTORS COMPANY

Rear Compartment Floor Panel Trim (1) - Install
Courtesy of GENERAL MOTORS COMPANY

Cargo Tie Down Loop (3) - Install [2x]
Cargo Tie Down Loop Bolt (2) - Install and tighten [2x] - Fastener Specifications
Cargo Tie Down Loop Bolt Cap (1) - Install [2x]