Installation Procedure
Rear Side Door Weatherstrip (1) - Install
- Place the rear side door window into the window channel.
- CAUTION:
Refer to Fastener Caution .
Rear Side Door Window Weatherstrip Bolt (1) - Install and tighten - Fastener Specifications
Rear Side Door Window Rear Channel Bolt (1) - Install and tighten - Fastener Specifications
Position the rear side door weatherstrip (1) into the rear side door window upper reveal molding.
- Lift the rear side door window all the way up in the channel and tape window in place.
Place the window regulator in the full up position until window is seated into the rear side door window regulator sash clamp.
- Rear Side Door Window Regulator Sash Clamp Nut (1) - Tighten [2x] - Fastener Specifications
Press firmly to install the rear side door window inner sealing strip (1) on the door flange.
- Rear Side Door Window Inner Sealing Strip (1) - Install
Rear Side Door Window Belt Reveal Molding (1) - Install
Rear Side Door Window Belt Reveal Molding Bolt (1) - Install and tighten [2x] - Fastener Specifications
- NOTE:
When reinstalling water deflector ensure integral locators are installed properly and that water deflector is secured and leakproof.
Route the rear side door inside handle cable through hole in deflector.
- Rear Side Door Water Deflector (1) - Install
Rear Side Door Pull Handle Bracket (2) - Install
- Rear Side Door Trim Bolt (1) - Install and tighten [2x] - Fastener Specifications
- Rear Side Door Trim - Install - Rear Side Door Trim Removal and Installation
- Ensure the window system operates properly.