LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2021 >> CT4 Sport, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 143 (Fixed And MOVEABLE Windows) >> Repair Instructions >> Front Side Door Window Weatherstrip Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2022 Cadillac CT4. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:

Refer to Glass and Sheet Metal Handling Warning .

WARNING:

Disconnect the power window switch when working inside the door. When operated, the Express Up/Down Feature allows the door window to move very quickly, without stopping, which could cause personal injury.

WARNING:

When installing the water deflector, ensure that the water deflector is securely fastened to the door inner before installing the door trim. An improper seal of the water deflector against the door inner may affect the ability of the front door pressure sensor to detect a side collision. This may result in improper airbag deployment and could cause bodily injury.

  1. Disable the SIR system. SIR Disabling and Enabling
  2. Front Side Door Trim - Remove - Front Side Door Trim Removal and Installation
  3. GM5432065Courtesy of GENERAL MOTORS COMPANY

    Front Side Door Water Deflector (1) - Remove

  4. Route front side door inside handle cable through hole in deflector (1).
  5. GM5432128Courtesy of GENERAL MOTORS COMPANY

    Use a flat-bladed plastic tool to remove the push-in retainers.

  6. Front Side Door Window Garnish Molding Retainer (1) - Remove [2x]
  7. Pull outward starting at the front and moving slowly rearward to remove the window garnish molding (2).
  8. Front Side Door Window Garnish Molding (2) - Remove
  9. GM5463175Courtesy of GENERAL MOTORS COMPANY

    Lift the front side door inner window sealing strip (1) off the pinch-weld flange.

  10. Front Side Door Inner Window Sealing Strip (1) - Remove
  11. GM5431904Courtesy of GENERAL MOTORS COMPANY

    Disconnect all electrical connectors.

    12. NOTE:

    Leave 1 outside rearview mirror nut partially installed, secure the outside rearview mirror housing, and proceed to remove remaining outside rearview mirror nut.

  12. Outside Rearview Mirror Nut (1) - Remove [3x]
    13. NOTE:

    Remove outside rearview mirror housing and glass as assembly.

  13. Outside Rearview Mirror Housing (2) - Remove
  14. GM5471053Courtesy of GENERAL MOTORS COMPANY

    Front Side Door Window Belt Reveal Molding Bolt (1) - Remove [2x]

  15. Using the appropriate tool, start at the rear and work forward, lift the front side door window belt reveal molding (2) up to remove it from the door flange.
  16. Front Side Door Window Belt Reveal Molding (2) - Remove
  17. GM5471114Courtesy of GENERAL MOTORS COMPANY

    Place the front side door window in the full up position and tape in place.

  18. Front Side Door Window Regulator Sash Clamp Nut (1) - Loosen [2x]
  19. Place the front side door window regulator in the full down position.
  20. GM5314209Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Use care when removing the front side door window (1) not to scrape the glass against exposed metal edges inside the front side door frame.

    Remove the masking tape holding the front side door window (1) and lower the window downward while pulling up on the front to remove the window from the door frame.

  21. GM5483681Courtesy of GENERAL MOTORS COMPANY

    Start at the rear upper corner of the door and pull the weatherstrip (1) down to release from the door frame.

  22. Front Side Door Window Weatherstrip (1) - Remove
scientia non olet · About LEMON Manuals