Removal Procedure
Reposition the seat as necessary to access the retaining clips.
- Using a flat-bladed plastic trim tool, release the retaining clips.
- Front Floor Console Extension Panel - Right Side (1) - Remove
Reposition the seat as necessary to access the retaining clips.
- Using a flat-bladed plastic trim tool, release the retaining clips.
- Front Floor Console Extension Panel - Left Side (1) - Remove
Front Floor Console Bolt (1) - Remove [6x]
- Front Floor Console Bracket Bolt (2) - Remove [2x]
- Disconnect the front floor console harness connector on both sides of the front floor console.
- Release the tabs (3) on both sides of the front floor console.
Slide the front floor console (1) enough to clear the instrument panel lower center trim panel.
Front Floor Console Variable 1 Liner (1) - Remove
- Use a plastic trim tool to release the transmission control lever boot (2) from the front floor console trim plate.
- Disconnect the electrical connector (3).
- Front Floor Console Trim Plate Bolt (4) - Remove [2x]
Remove the automatic transmission control lever knob (1) by pulling up and releasing the retainer.
Front Floor Console Trim Plate (1) - Remove
Front Floor Console Rear Cover Bolt (1) - Remove [2x]
- Front Floor Console Rear Trim Panel (2) - Remove
- Disconnect the electrical connectors.
Front Floor Console Cup Holder Bolt (1) - Remove [5x]
- Loosen the front floor console cup holder enough to release the retainer clip attached to the front floor console armrest (3).
- Front Floor Console Armrest Bolt (2) - Remove [7x]
- Front Floor Console Armrest (3) - Reposition
- NOTE:
Observe the mounting and location of the wiring harness to ensure proper reinstallation.
Release the front floor console compartment lamp wiring harness (1) from the front floor console compartment.
Release the retaining tab.
- Front Floor Console Compartment Lamp (1) - Remove
- Disconnect the electrical connector.