Secondary Camshaft Drive Chain Components Removal - Right Side
WARNING: This page is about a different car, the 2022 Cadillac CT4. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
The timing chain tensioner plunger is under high tension and must be retained by using the tensioner retraction pin during removal or installation of the timing chain tensioner. Failure to retain the timing chain tensioner plunger may cause it to be ejected with intense force and cause personal injury.
Rotate the engine clockwise until the right hand bank camshaft flats with laser etched markings are straight up in relation to the cylinder head. The crankshaft key way will be at approximately the 3 o'clock position.
- Compress the plunger into the body and lock the right timing chain tensioner by inserting EN-52234 Timing Chain Tensioner Retaining Pins or 1/8" drill bit into the access hole in the side of the right timing chain tensioner body.
- Slowly release pressure on the right timing chain tensioner. The right timing chain tensioner should remain compressed.
- Timing Chain Tensioner Bolt (1) - Remove [2x]
- Timing Chain Tensioner- Right Side (2) - Remove
- Timing Chain Housing Gasket- Right Side (3) - Remove and DISCARD
- Timing Chain Guide Bolt (4) - Remove
- Timing Chain Guide- Right Side (5) - Remove
- Timing Chain Guide Bolt (6) - Remove [2x]
- Timing Chain Guide- Right Side (7) - Remove
- Camshaft Intermediate Drive Chain- Right Side (8) - Remove