Diagnostic Aids
WARNING: This page is about a different car, the 2022 Cadillac CT4. However, it is still accessible from the selected car via links, so may be relevant.
- These DTC's can be set when programming the K20 Engine Control Module. Please follow the programming and setup instructions if a DTC sets.
- The last 2 digits of the circuit number are significant in identifying its power and ground functions.
- Circuits ending in 42 are primary fused B+ circuits (generally the first fuse in the circuit after the battery)
- Circuits ending in 40 are secondary fused circuits (generally fuses in a fuse block after the primary circuit)
- Circuits ending in 39 and 41 are ignition voltage circuits.
- Circuits ending in 50 are grounds.
- Circuits ending in 51 are low reference (ground) circuits.