Circuit/System Testing - Starter System Test
WARNING: This page is about a different car, the 2022 Cadillac CT4. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition On vehicle in service mode.
- Remove the Kr27 Starter Relay.
- Perform the scan tool control function: Command the Starter Pinion Solenoid On.
- Verify a test lamp does not turn On between the test points:
M64 Starter Motor Terminal 1 X1 & Ground.
- If the test lamp turns On
Repair the short to voltage on the circuit 6
- Go to next step: If the test lamp does not turn On
- If the test lamp turns On
- Replace the M64 Starter Motor.